Cable Management Arm
Cable management for sliding equipment
- 1U and 2U sizes available
- Secure equipment and network sliding equipment
- Fully adjustable
- Compatible with square or round hole racks
- Designed for equipment with slide rails
Dell, HP, and IBM compatible
- Significantly smaller than OEM CMAs
- Mounts on left or right side of rack
- 28.5" - 33" (724 - 838 mm) extension
The cable management arm is compatible with most types of equipment. It is a fully adjustable, ruggedized solution. There are a number of ways to attach the cable management arm to different types of equipment. Some OEM cable management arms take up too much space in the rack. This cable management arm is very compact and will typically not have any type of obstruction issue caused by OEM cable management.
| Made In America | Yes |
|---|---|
| BABA Compliant | No |
| RoHS Compliant | Yes |
| TAA Compliant | Yes |
| UL Compliant | No |
| ETL Compliant | No |
| Country of Manufacture | United States |
| Finish | Zinc plated |
| Dell Part Number | 1UCMA-137: A0948134 2UCMA-137: A0788067 For a full list of Dell SKUs setup in the Dell ordering system visit our Dell SKU page. |
| Synnex Part Number | 1UCMA-137 - 6194583 2UCMA-137 - 6303002 |
| Ingram Part Number | 1UCMA-137 - L45356 2UCMA-137 - L45252 |
| Tech Notes | Fits equipment that the measurement between back of the equipment to rear upright is 29" to 33 1/2" when fully extended. |
Download 1U Cable Management Arm (1UCMA-137) Installation Instructions (opens in a new tab)
Download 1U Cable Management Arm (1UCMA-137) Dimensional Drawings (opens in a new tab)
Download 2U Cable Management Arm (2UCMA-137) Installation Instructions (opens in a new tab)
Download 2U Cable Management Arm (2UCMA-137) Dimensional Drawings (opens in a new tab)